Pyronix Paragon Super Spezifikationen PDF herunterladen (Seite 11)

1118

RDOC279 issue1

S+S+

S+

10.1.8 Omitting one or more zones

If one or more immediate zones are triggered whilst in exit mode a low pitched error tone

will be produced. If this occurs return the panel to DAY mode by entering either the

Master code or Limited User code. If the log is then viewed any faulty zones will be

displayed as above. First check for any obvious reason for these zones to have been

activated. This may simply be due to a monitored door or window being left open or a pet

being left in a protected area. If the fault cannot be rectified it is possible to omit faulty

zones but this should only be used as a last resort if the building is to be left unoccupied.

Example:

Set panel (error tone will be heard).

Unset panel (alarm LED will be flashing).

View log to see which zones are faulty

and investigate fault(s) if possible.

Set panel,

then: If no error tone heard, exit via normal route.

or: If error tone heard:

Enter:

then; number(s) of zones to be omitted (1 to 6)

then: - Entry / Exit timer will start again.

then: exit building by normal route.

10.2 MASTER USER FACILITIES

The Master has access to all the Limited User facilities as well as those listed below. The

Paragon Super control panel has to be in day mode after resetting with the Master code

for these additional features to be accessed.

10.2.1 Event Log Reset

Enter:

This feature will only operate if, whilst programming, the engineer

selected the feature allowing the Master User to clear event log.

10.2.2 Resetting alarm LED after an Activation

Turn system off / back to Day Mode

Enter: Master User Code

or Limited User Code

Alarm LED will be flashing View log

Enter Last event will appear on the 7 segment display

Scroll through events:

Backwards

Forwards

To clear 7 segment display

Enter

8.5 LOW VOLTAGE CONNECTIONS

Extension loudspeakers (SPK)

Minimum 8 Ohms load or 2 x 16 Ohms in parallel.

SPK- (B - terminal) : 0 volts

SPK+ (SPK terminal) : speaker supply

Strobe Lamp STB (-terminal) : negative trigger

External Sounder/Bell

BA : negative trigger

S+ : 12 volts dc supply

B- : 0 volts

BT : Bell Tamper (Negative return)

Wiring for External Sounder: PANEL SOUNDER

Wiring for mechanical bell:

(non self actuating) PANEL BELL

Remote keypads

AUX- : 0V supply

KD : data transmit/receive

AUX+ : 12 volts dc supply

KT : keypad tamper

1 2 ... 6 7 8 9 10 11 12 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare

Pyronix Paragon Super Spezifikationen Seite 11

Kommentare zu diesen Handbüchern