Pyronix Paragon Super Spezifikationen PDF herunterladen (Seite 12)

RDOC 279 issue 2

AUX-

AUX+

AUX-

AUX+

Wiring a single remote keypad. This requires 4 core cables.

Wiring for multiple remote keypads (daisy chain). This requires 4 core cable.

PANEL RKP

Wiring for multiple remote keypads (star configuration). This requires 5 core cable.

PANEL RKP1 RKP2

Alarm, P.A and Fire Zones

Wiring for normally closed contacts.

Wiring for normally open contacts.

Enter Volume will be determined by volume pot. i.e Reduced volume

10.1.3 Unsetting the panel

The panel can be unset by entering the building via the entry exit route and then keying

either of the two user codes.

10.1.4 Activating the Personal Attack Alarm (PA)

To activate the Personal Attack Alarm enter

10.1.5 Activating the Fire Alarm

To activate the Fire Alarm enter

10.1.6 Turning Chime On and Off (Panel must be in day mode)

Enter

The status of the chime facility is indicated by the chime LED on the front of the control

panel. When the chime mode is selected a two tone chime will be produced

by the internal sounder and any extension speakers when an Entry / Exit zone is

activated. The same key sequence can be used to turn off the chime facility.

10.1.7 Reading Event Log (Panel must be in day mode)

Enter

The day led will flash and the most recent event stored in the log will be displayed. If the

up arrow key is pressed the previous log entry will be displayed. Similarly if the down

arrow key is pressed the next most recent entry will be displayed.

The event log can be scrolled backwards and forwards using the up and down arrow

keys to allow the last 18 events to be viewed.

To leave this function press the key. An error tone will be produced if an attempt

is made to scroll outside either end of the event memory. The table below shows the

symbols stored in the event log and their meanings.

Entry/Exit zone activation.The panel was not unset before

the end of the entry time period, or User did not leave in time.

to Activation of a programmable zone.

This shows the next event in the log has triggered the alarm

system.

This shows that a zone was omitted and refers to the

number which precedes it in the log.

Tamper fault or sabotage.

Personal attack activation.

Fire alarm activation.

Panel

RKP 1

Panel

RKP 1

RKP 2

Panel

RKP 1

RKP 2

1 2 ... 7 8 9 10 11 12 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare

Pyronix Paragon Super Spezifikationen Seite 12

Kommentare zu diesen Handbüchern